News categories
NewsLocation:Home >> News
Solder type terminal block
  Published:2016-01-13 08:25:29   Views:

LG high-low design can provide multilayer wiring, between layer and layer arrangement is very compact, and stagger half stitch in the vertical direction,terminal completely conform to the compact layout, save space of the design requirements. LG double terminal cater to lead trend, terminal on the lower staggered half stitch welding, facilitate the lower connection operation, stitch welding stays the same. LG series double terminal without interlayer displacement, especially suitable for installation on the printed circuit board. LG large printing lines board structure and small terminal LG series products differ in size, and the diameter of screw head, welding needle pitch 6.35 mm / 7.6 mm / 9.5 mm / 10.0 mm / 10.16 mm / 12.7 mm / 15.0 mm, but access to the largest section of the wire is larger than the corresponding small terminal.

Product introduction 

1. Provide a variety of pitch 2.5/3.81/5.0/5.08/5.0/5.08/7.62/9.52/10 mm, meet customers' different requirements.


2. LG straight welded type terminal characteristics: simple structure, small volume, convenient wiring, wires without injury.


3. The principle of using wire clamp body lifting, leg and wire clamp body is divided into two parts, shell solid, pitch length accurately.


4. Adopt fog tin, bright tin material for electroplating terminals.


5. Direct welding terminal is suitable for the field of power industry, controller, entrance guard system, etc.